- Expansion of 15 to 20% on drying
- Easy to apply
- Fast setting time
- Easy to rework feedthroughs without modifying the existing caulking.
EI 120 : Fire resistance
+15 to 20% : Expansion on drying
35L : 25kg bag fills a volume of 35L
SolidPART is an expanding mortar to be mixed with water
Minimum 2h fire resistance, depending on the configuration
Guaranteed halogen and asbestos-free
Sealing of small to large openings (up to 1,200mm x 800mm) with multiple penetrations
Wall or slab configurations
Supports: masonry, concrete
- Clean and degrease the surfaces
- Moisten surfaces
- If necessary, make a light formwork (cardboard, polyane, etc.)
- Gradually add 25kg of mortar into water and mix until the desired consistency is obtained: thick (10L of water) to fluid (13L of water)
- Pour the mortar into the opening, possibly using a mortar pump
- Smooth out if necessary, with a trowel
- Clean tools with water immediately after use
- Allow to dry for 16 hours before removing the formwork to avoid surface delamination. Attach the compliance label
- Base: cement (powder)
- Colour: grey
- Density: approx. 0.8kg/L
- Packaging: 25kg bag
- Shelf life: 6 months (date of manufacture)
- Thermal conductivity (according to ISO 8302): 0.22 W/(m.K) at 10°C
- Refer to the product safety data sheet
- Wear suitable PPE: gloves and protective goggles
- EFECTIS report 13-A-492-Rev1
- Tested according to European standard EN 1366-3
- Declaration of performance
SolidPART is an expanding fire wall mortar for sealing electrical or mechanical penetrations and ducts.
Available in 25kg bags to fill a volume of approximately 35L
- Expansion of 15 to 20% on drying
- Easy to apply
- Fast setting time
- Easy to rework feedthroughs without modifying the existing caulking.
EI 120 : Fire resistance
+15 to 20% : Expansion on drying
35L : 25kg bag fills a volume of 35L
SolidPART is an expanding mortar to be mixed with water
Minimum 2h fire resistance, depending on the configuration
Guaranteed halogen and asbestos-free
Sealing of small to large openings (up to 1,200mm x 800mm) with multiple penetrations
Wall or slab configurations
Supports: masonry, concrete
- Clean and degrease the surfaces
- Moisten surfaces
- If necessary, make a light formwork (cardboard, polyane, etc.)
- Gradually add 25kg of mortar into water and mix until the desired consistency is obtained: thick (10L of water) to fluid (13L of water)
- Pour the mortar into the opening, possibly using a mortar pump
- Smooth out if necessary, with a trowel
- Clean tools with water immediately after use
- Allow to dry for 16 hours before removing the formwork to avoid surface delamination. Attach the compliance label
- Base: cement (powder)
- Colour: grey
- Density: approx. 0.8kg/L
- Packaging: 25kg bag
- Shelf life: 6 months (date of manufacture)
- Thermal conductivity (according to ISO 8302): 0.22 W/(m.K) at 10°C
- Refer to the product safety data sheet
- Wear suitable PPE: gloves and protective goggles
- EFECTIS report 13-A-492-Rev1
- Tested according to European standard EN 1366-3
- Declaration of performance
